The Me Creator Geeetech Extruder issue solved

  Many of Customers have complained  about the clicking sound of the extruder , The problem is in the firmware , you need to get the latest geeetech firmware and re-flush your controller, all three cases have been resolved. Problem The ext-ruder stepper motor was not function properly as shown in the following video . ... cslist_api Diagnosis : After checking the connection and the steeper controller , the connection from the stepper side was not good. Once the connection fixed , the 3D printer is functioning properly. Here is a discussion in Geeetech Forum ( Look for Digitmakers final updates)

Previous Post Next Post

  • 122
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields