Wanhao Duplicator i3 Extruder issue Resolved

RSS
Many customers who bought the Duplicator i3 from wanhao are new to 3D printing . Many of them asks our technical support team about the extruder doesn't extrude filaments , or the printer is inconsistent in extruding filaments. DigitMakers Technical Support Team investigate the issue and found that the extruder fan was not on which led to the extruder gear to heat up and deform the PLA filaments as shown below . IMG-20150602-WA0002 Solution :  Make sure that the Extruder Fan is on during printing . You can set it on from LCD Control Panel ;Or from Cura Advance Setting Tab- click the button next to the Enable Cooling Fan,   then set the "full fan on " at hight " instead 0.5 (default ) to Zero (0) mm . This problem will disappear :)  
  Here is the customer having a good part after our Support Team solved the issue .    [caption id="attachment_3053" align="alignright" width="342"]Good Part from Duplicator i3 Good Part from Duplicator i3[/caption]

Previous Post Next Post

  • 122
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *

Please note: comments must be approved before they are published.

* Required Fields