BondTech Makerbot Replicator 2 Kit

BondTech Extruder Kit for Makerbot Replicator 2

This kit provides a upgrade for Makerbot Replicator 2 feeding system with the ability to print faster with improved quality. The adjustable thumbscrew allows you to fine-tune the force acting on the filament. The Dual Drive system ensures that the extruder never looses grip of the filament, so grinding and slipping are a thing of the past.

• Bondtech Dual Drive gears
• Single nozzle
• Adjustable tension for fine-tuning filament pressure
• High-performance material feeding system
• Housing parts are professionally SLS printed in polyamide for maximum strength and precision
• Replaces the original feeder and coldblock
• The original motor are used 
• PTFE feed tube is held securely in place with an industrial 6mm push-fit connector for reliability
• Installs in about half an hour with standard tools available
• Full installation guide available here (the installation guide is for a Makerbot Replicator 2X but follows the same steps)

Please Note: 

This block has an M6x1.0 thread through the coldblock for the factory default heatbreak. Please verify that your heatbreak fits before placing your order. 

On the factory setup there is a low height nut both over and under the coldblock. With this setup, the top nut needs to be removed.