Welcome to Digitmakers.ca!
Push-fit connector in heavy-duty metal
4mm push fit is for 1.75mm filaments
6mm push fit is for 2.85mm filaments
Replacement Push-fit Collar with metal teeths
Push-fit Connector in brass for 4 mm tube.
4 mm assembles in 8.0 mm pocket with a minimum depth of 5 mm.
Brass Pneumatic Fitting Connector
Direct Pneumatic push in fitting for:6mm(OD) PTFE Tube
This is a push fit kit including clips for 3D printers.
These are couplings with which a Bowden tube is fixed to the hotend or extruder.
The contents of the delivery consists of the parts shown in the photo.
Direct and Quick Replacement Hot End Assembly for Creality 3d printers. Includes everything you see in the picture.
Terminal & Pins (4 each)
Teflontube @ Pneumatic Fitting (Extruder side)
Direct Replacement M6 Pneumatic push in fitting for Creality 3D Printer Extruder Side Pneumatic Connector
These pneumatic fittings are designed to provide a simple and cost-effective way of inserting Bowden tubing directly into your printed or plastic components.
This listing is for the collet only, for use with 1.75mm filament.
Original Flashforge Pipe Joint for Adventurer 3 3D Printer.
Pipe joint connecting filament tube to extruder.
Click here for extruder bracket.
Original Flashforge Extruder Bracket for Adventurer 3 3D Printer.
Pipe fitting not included. Click here for pipe fitting.
This is a neat little solution for quickly and easily converting a direct extruder that would normally accept a groove mount hotend into a bowden extruder. Simply mounts in like a hotend, but instead accepts our PTFE tubing securely in an embedded bowden coupler.
Quite a bit nicer than forcibly screwing a threaded bowden coupler into a printed h...
Direct Replacement M10 Pneumatic push in fitting for Creality 3D Printer Hotend Side Pneumatic Connector
Creality CR-10 MINI
Creality CR-20 / Creality CR-20 Pro
Ender 3 / Ender 3 Pro
Made in USA by Micro Swiss
Part #: M2594
Micro Swiss hotend for CR-10 / Ender Kit
Micro Swiss hotend for CR-10s Pro Kit
1x Bowden Collet
1x Red Clip
These high-quality pneumatic push-fit couplings screw directly to the bowden heat sink or any printed parts you may have that need to be converted to take PTFE tubing.
They are drilled out so that the PTFE tubing will run all the way through the fitting and into the part that you are screwing it into.
For 4mm OD Tubing.
Thread Length: 10mm.
1111 Flint RoadUnit #12North York, ONM3J 3C7
TOLL FREE: 888-635-7113
LOCAL NUMBER: +1 416-739-1515