Welcome to Digitmakers.ca!
Tech-G was specifically designed to address two specific problems with PLA and ABS filaments. In case of PLA, it was brittle nature which severely limited functional testing and ABS was limited in its tensile strength. Hence, Taulman launched a new high-strength PETG which had much higher tensile strength than ABS and more elongation than a typi...
Flashforge Creator 3 Extruder Board. Original spare part.
Complete hot end assembly including fan duct , hot end , heater cartridge & thermistor.
1- Build Plate Carriage Plate
2-Zaxis Motor with Lead screw and nut .
3- Zaxis two shafts with linear bearings .
4- Plastic Covers and Zaxis Holder.
Push-fit Connector in brass for 4 or 6 mm tube.
4 mm assembles in 8.0 mm pocket with a minimum depth of 5 mm.
6 mm assembles in 13.4 mm pocket with a minimum depth of 6 mm.
1111 Flint RoadUnit #12North York, ONM3J 3C7
TOLL FREE: 888-635-7113
LOCAL NUMBER: +1 416-739-1515