Genuine BLTouch Auto Bed Leveling Sensor v3.1 by ANTCLABS

New BLTouch version 3.1 with 1.6mm longer stroke is an auto leveling sensor for 3D Printers based on open-source. 

• Smart
• Simple
• High-precision

Compatible with CR-10s Pro when using Marlin 2.0 firmware.

Simple

BLTouch can be easily applied, since it has a small and simple structure. Gathering information & firmware setting will be an easy task, because main functions and controls of BLTouch are same as usual auto bed leveling sensor, consists of RC servo and micro switch.

Smart

Self-test : The push pin operate two times in a test when the power is on. Alarm : The LED light blinks if a problem was found on a self-test or during operation.

High-precision

BLTouch fulfilled simple structure and high precision by using progressively designed solenoid and hall sensor. BLTouch's Standard Deviation in repeatability is around 0.005mm.

Wire Length: 7"

Commonly purchased with BLTouch Extension Cable 1.5 meters SM-XD, BLTouch Extension Cable 1.5 meters SM-DU or BLTouch Extension Cable 1.5 meters SM-FB-1500