Creality CR20 Pro unboxing and First Print Review@Digitmakers.ca 18

Cr20 Pro provides great features that enable users get better printing experience from other machines like Ender3 pro and other basic 3D Printers . The machine easy to assemble and operate . we have encounter only one issue during the calibration process and it was easily resolved . 

Shining Einscan SE 3d scanner Case Study 27

EinScan SE provides high scanning capability and performance at affordable price. 

Wanhao D9 Build Tips 12

Build Tips: Wanhao D9

Issue : Z banding when printing objects at 45mm/sec when each layer is more than the time the slicer slows down the print speed. This is only visible on the Y axis.

This can be due to the alignment of the Z carriage (Plate where there are 3 rollers per side) 

Steps

Remove the extruder assemble as per building instructions.

Unplug X motor and end stop wire.

Remove the X carriage assembly

Notice the bolt holding the t-nut is loose. ½ turn loose from hand tight.

Mount the X axis back to the plates slowly tightening both sides equally. If the mount is loose on the tnut, turn the mount 1/8 at a time then re tighten

Do another test print with the same gcode.

Keep in mind to check all belts.

Align Z motor against the threaded z rods.

The alignment of the motors are often not centered on the Zrod. This will yield an uneven print on the Z axis. This is mostly visible on 90 degree wall but not visible on irregular shapes.

1. Loosen 4 (2.5mm)  screws on the motor

2. Make sure that the screws on the lead screw nuts are secured. Move the Z axis all the way to the bottom.

3. Move the motor freely to align against the treaded rod. Slowly tighten the 4 screws in an X pattern

Can't Find What you looking for ? 3

Please enter it in this suggestion Mind Map and we will do our best to source it for you . 

Wanhao Duplicator 9 Adjustment Process 50

Wanhao Duplicator 9 has very rigid structure . During shipping the vslot wheels tension-er might get loose and result in prints finish issues . 

In this post we will provide step by step guide on how to set the wanhao D9 to get great prints . 

1- Check the the vslot wheels for the y, x and z axis  by moving them sideways and see if they are loose or too tight the screw set --marked with arrows in Fig(1)  --as required . 

2- Loose the z axis lead screw nut by loosing the four screw marked below both sides . This way any binding in the z-axis will not affect the print quality (see Fig.(2))

3- Remove the tension springs off the belt and readjust the x-axis and y-axis belts as shown (Fig.3)

Our 3d printers makes amazing quality !

Print Quality Troubleshooting Guide 11