CR10S Pro Unboxing and First Print

RSS
CR10S Pro Unboxing and First Print

CR10S Pro has advance features like Powerfull PSU , Bondtech Extruders Gears and Others 

Un-boxing and Installation : 

Takes 15-20 min to put the machine together , the manual contains enough details to help new users to assemble the machine. 

Build Plate Leveling and First Print 

After following the Auto-leveling process , and adjusting the screw , the machine leveling process is not easy ,The Machine is useable by adjusting the live Z offsett while printing , however  Creality sent us Upgraded Firmware for the LCD and the Controller . 

Firmware can be Downloaded here 

Here is how did we flash the firmware . 

1- Open the bottom cover of the machine; unscrew the bottom cover , and two screws on each side of the printer

cr10s pro

Fig(1)

2- Using FAT32 formatted Microsd card unzip the content of the LCD folder , and copy/paste in the Microsd card . 

3- Insert the sd card as shown in Fig(2) and turn the printer power on, wait for 10 min until the LCD screen firmware is completed. 

upgrading CR10S pro

4- Now Connect the printer to the PC using USB cable , and make sure that the slicer recognize the printer , and the printer is connected to the PC with the right USB port , and Baudrate should be 115200 ( if you require more information , please refer to the instructions located in the Firmware Zip File link Above. ) 

5- Select CR10S profile , Click on Machine Tab , then Install Custom Firmware .

6- Locate the Hex File and wait until you complete the installation . 

 In conclusion , the new firmware helps a little leveling the bed , yet live z offset is very important  to get the right distance between the nozzle and the bed. 

 

 

Previous Post

  • DigitMakers Team
Comments 0
Leave a comment
Your Name:*
Email Address:*
Message: *
* Required Fields