E3D V6 Hotend Full Kit - 1.75mm 12V/24V Universal

E3D-v6: Smaller - Easier - Higher Performance.

Print the Widest Range of Materials Possible.

Building on E3D's signature high temperature performance that allows you to print high temperature materials E3D has now focused on adding increased functionality with soft and flexible filaments. By providing a PTFE liner tube through the hotend that you can extend into your extruder this gives the ability to add the confinement and constraint needed to make excellent quality prints with flexible filaments like NinjaFlex, FlexPLA and FlexPolyester. This opens up a huge range of new opportunities for your printer.

(PTFE Liner only present in 1.75mm version - 3mm Bowden has partial lining - 3mm Direct has no lining)

This above cutaways show the internals of all three HotEnds. Left to Right: 1.75mm Universal, 3mm Direct, 3mm Bowden.

High Temperature Performance.

With no PEEK or PTFE in hot regions of the E3D V6 HotEnd you can reach 300C with the supplied thermistor. By swapping a thermistor for a thermocouple (may require additional electronics) you can reach over 400C. 

This not only allows you to print extremely high temperature materials like Polycarbonate and Nylons but also eliminates HotEnd meltdown failures associated with PEEK/PTFE designs. Although E3D's latest v6 hotend has a PTFE liner inside the hotend this liner is never subjected to high temperatures so there is no risk of damaging the liner through overheating.

The new HeaterBlock gives the fastest heat up times and the most responsive temperature control by clamping around the cartridge for maximum thermal contact. The new thermistor placement means you get the most accurate temperature readings with the fastest response. What this means for you the user, is that you can go from 20C to 200C in just 65 seconds, temperature control is responsive enough that you can keep the hotend within 0.5C of your set temperature or less with ease.

Package Contents:

• Genuine assembled E3D V6 Full Kit for 1.75 mm filament
• 12V or 24V heater cartridge 30 Watt
• Thermistor
• 0.4mm brass nozzle
• V6 silicone sock
• Fan and Shroud 
  
• 0.8m PTFE tube

No reviews yet.