Your cart is empty
Looks like you haven't added anything to your cart yet
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent is lower.
It’s the ultimate filament dryer you need for quality 3D printing!
Digital Display
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
The temperature readings are directly measured at the tip of the temperature sensor located about 15 mm away from the hot air vent under the following conditions.
-
Ambient temperature is at 22C.
-
There are two full filament spools inside the dryer.
-
The dryer has been running at the set temperature for at least 1 hour
The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent is lower.
For example, under about conditions and the dryer temperature is set at 85C, the temperature at the tip of temp sensor will be 85-92C and the temperature right under the lid will be around 70C.
Double-wall Structure
Spool Adapter included
- 2 metal shafts
- 4 big spool adapters
- 4 small spool adapters
No reviews yet.
- Choosing a selection results in a full page refresh.