Prusament PETG V0 - 1.75 mm 1kg

Prusament PETG V0 is the one-in-the-world UL-certified self-extinguishing PETG filament. Similar to the regular Prusament PETG, it is a tough material with good thermal resistance. Its use is universal but it is especially suitable for housings and insulating parts in electronics, due to its self-extinguishing properties.

PETG V0 is not prone to warping, so printing large objects isn’t a problem. When our Prusament PETG V0 starts burning, it creates a carbonized crust on the surface that prevents the oxygen from getting in and fueling the flame and eventually extinguishes the fire.

Prusa asked the UL to test the flammability of the Prusament PETG V0. The test method was made according to the IEC 60695-11-10 standard and resulted in a class UL94 V0 (for both our colors). Here’s the Blue Card that serves as a certificate issued by the UL company.

Print preparation

This filament needs to be kept as dry as possible as it's more hygroscopic, compared to regular PETG. If you can't keep the filament dry, we suggest drying it before use for 6 hours at 55 °C.

Powder-coated Satin or TXT sheet provides good adhesion. Clean it with IPA (available in drugstores, for example) which works great not only with Prusament PETG V0 but with other materials too.

Pour a small amount of IPA on a paper towel and use it for cleaning the surface. To achieve the best results, clean the surface while it’s cold. Keep in mind that higher temperatures will evaporate the alcohol before cleaning the surface. Also, don’t forget that the heatbed preheated for printing Prusament PETG V0 has a high temperature (80 °C) and may burn you if you touch it! Another possibility is cleaning the surface with warm water and a few drops of dish cleaner on a paper towel. You can also use denatured alcohol.

Prosa doesn’t recommend printing with Prusament PETG V0 on a smooth PEI sheet. This material adheres strongly to the PEI surface and may cause damage to it. This type of damage is not covered by the warranty. If you need to print on a smooth surface, spread a thin layer of paper glue stick on it.

Printing Setup

Tips

This filament needs to be kept as dry as possible as it's more hygroscopic, compared to regular PETG. If you can't store the filament in dry conditions, we suggest drying it before use for 6 hours at 55 °C.

Notes

Prusament PETG V0 is made in-house by Prusa Research.
The UL certification is valid only when all rules set by the UL are followed. 
Before printing, make sure the surface of the print sheet is clean.
To dry the filament, please follow the instructions in Prusa's article.

DATA SHEETS

Certificate of Compliance

PETG VO TECHNICAL DATA SHEET

PETG VO SAFETY DATA SHEET

No reviews yet.