FormFutura ReFill PETG - 1.75mm 750g

ReFill PETG is manufactured for usage with re-usable master spools. Print your own spool. This filament reduces your carbon footprint significantly as packaging waste is reduced to an absolute minimum.

High Speed Compatible 350mm/s

With high speed 3D printing becoming more prominent due to the introduction of high speed 3D printers, FormFutura is excited to introduce a range of new and existing upgraded materials to our assortment. These materials, while still suitable for traditional printers, have also been fully optimized for the new high speed 3D printing technology. Do keep in mind that faster print speeds also require higher print temperatures.

ReFill PETG comes without a spool. It fits on a reusable master spool for the 750g version and reusable flanges for the 2000g version.
You can download the files to print your very own 750grams spool on our downloads page here or download the 2000grams variant here.

This solution is an effort to reduce packaging waste. This results in more efficient shipping and less pressure on the environment. 

Important key features

• Minimal packaging waste (no spool / box)
  
• Food contact approved according to EU directives
• Available in 0.75kg coils
• Very easy to 3D print

Suitable applications

• Functional prototyping.
• Waterproof applications.
• Snap fit components.
• Mounts, jigs, and fixtures.
• Signage.

Reduce your carbon footprint with ReFill PETG

FormFutura ReFill PETG isn’t spooled on a disposable spool. It comes on a coil and fits on reusable master spools.
ReFill coils are only packaged in reusable vacuum-sealed zipper bags. These zipper bags can be (re)used for storing your various filaments!

General printing guidelines *

*) Above displayed settings are meant as guidance to find your optimal print settings.
These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer.
There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

PRINT THE MASTER SPOOL

Refill Version 1

ReFill PLA comes without a spool. It fits on a reusable master spool for the 750g version and reusable flanges for the 2000g version. You can download the files to print your very own 750grams spool on our downloads page here or download the 2000grams variant here. This solution is an effort to reduce packaging waste. This results in more efficient shipping and less pressure on the environment.

Reloading the spool V 1.0 – 750g

Using larger variants V 1.0 – 2kg

Introducing ReFill Version 2

After experimenting with Refill even more after its initial release, we found we could make further improvements on it. One thing some users found was that the hold of the printed 2kg spool was not strong enough and could potentially fall off. To negate this issue, we introduced a new system for all our variants where the spool is secured with velcro, which can then be reused to secure the spool on your filament coil. This does require a new and improved printable model of the spool, which can be found by visiting  Printables page.

DATA SHEETS

Technical Data Sheet

Safety Data Sheet

Compliance *

This filament is compliant to below listed directives and regulations.

• RoHS directive 2011/65/EC
• REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.

No reviews yet.